June 29th 2012
Started at 8 PM and ended at 9"15 PM
Started by filing smooth the hole in Left Wing rear spar for the aileron balance arm.
Drilled hole and placed grommet for aileron trim cable. Drilled 3/8" hole, put in grommet, ran cable thru forward-most lightening holes of rear ribs. 10" left sticking out to attach to aileron trim tab.
Threaded red, green, and yellow 16 ga. mil spec wire for Nav/StrobeSync thru spar end lightening hole and through forward most rear rib lightening holes. Also threaded blue and white wires thru for landing and taxi lights.
Was going to do cable ties, but I think I left them at home :(
Threaded stainless braided AN-6 fuel line through 1st two nose ribs w/ grommets. Put on Female AN-6 fitting using the Kool Tool. Will refit grommets arond AN-6 hose tomorrow. Trying to get home early!
0 Comments:
Post a Comment
Subscribe to Post Comments [Atom]
<< Home